Filter
Top Products
Problem Possible cause
Solution
If the malfunction shows again ,contact the
Service Center.
These data are necessary to help you quickly
and correctly. Write the necessary data here ,
refer to the rating plate.
Model description ..................................
(Mod.)
Product number ...................................
(PNC)
Serial number ...................................
(S.N.)
.
Technical data
Dimensions
Rising Time
Height
Width
Depth
1687 mm
554 mm
551 mm
10 hours
For further technical information please refer to the rating on the internal left side of the appliance and in the
energy label.
Installation
Read the Safety information”carefully for
your safety and correct operation of the
appliance before installing the appliance.
Install this appliance at a location where the
ambient temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Positioning
Unusual noises
Appliance is not level.
The appliance is touching the
wall or other objects.
Re-adjust the feet.
Move the appliance slightly.
A component , e.g. a pi pe ,on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary ,carefully move the
component out of the way.
Replacing the lamp
Before replacing the lamp ,shall
disconnect the appliance from mains
power supply..
Caution!
Lamp specification: 220-240V ,max. 15W
Follow below process to replace the lamp:
1. Set the temperature regulation knob at num-
ber “0” to switch off the appliance.
2. Unplug the appliance to make sure the
appliance is disconnected from main power
supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. According to the direction showed in below
picture ,unscrew the lamp.
6. Fit new lamp according to the opposite
direction ,then replace the lamp cover and
screw.
7. Plug in the appliance and regulate the knob
to right position.
7