Filter
Top Products
15
Ventilation Requirements
The appliance must have adequate ventilation to
ensure correct operation.
Diagram shows the ventilation requirements when
installed:
A:* Under a worktop, or cupboard.
* The clearance space of 10 cm above the
appliance may be reduced to 5 cm providing a
clearance space 2,5 cm is left on either side of
the appliance.
B: When freestanding
Door Reversal
If required the opening direction of the door can be
changed as follows:
To reverse the bottom hinge assembly proceed as
follows:
Disconnect the appliance from the electricity
supply.
Tilt the appliance backwards, resting the top edge
of the appliance on a stool or something similar.
Unscrew the adjustable feet situated on both sides
at the front (2 pieces). Remove the lower door
hinge plate by unscrewing the 3 retaining screws.
Remove the hinge pin from the bottom of the door.
Slot the hinge pin into the hole in the hinge plate
and relocate the hinge assembly to the opposite
location and refit using the retaining screws.
Put the cabinet in the upright position.
2
1
Levelling
The appliance must be level. Level the appliance by
adjusting the two adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be removed.
The plastic bag of accessories also contains two
spacers to be fitted into special holes in the back
of the appliance. Fit the spacers into the holes,
taking care to ensure that the arrow (A) is
positioned as shown in Figure. Then turn them
through 45° (arrow (A) vertical) until they lock
into place.
PR60
A
45°