Filter
Top Products
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to
open enough so that the shelves can be removed.
Warning!
It must be possible to dis-
connect the appliance from
the mains power supply; the
plug must therefore be easi-
ly accessible after installa-
tion.
min.100 mm
15 mm
15 mm
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
To change the opening direction of the door, do these
steps:
1. Remove the plug from
the power socket.
2. Tilt back the appliance
carefully so that the com-
pressor cannot touch the
floor.
3. Unscrew both adjustable
feet.
4. Unscrew the screws of
the door bottom hinge.
5. Take off the appliance
door by pulling it slightly
downwards.
6. Unscrew the top door
hinge pin of the appliance
then screw it back on the
other side.
7. Fit the appliance door on
the upper door hinge pin.
8. Remove the lower hinge.
Put over the pin in the di-
rection of the arrow.
9. Unscrew and install the
screw on the opposite side.
10. Install the lower hinge
on the opposite side leav-
ing the position of the door
unchanged.
11. Screw in the one screw
in the place set free on the
other side as well as the ad-
justable feet (2 pieces).
12. Remove and install the
handle
1)
on the opposite
side.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
9