Zanussi ZSF 2400 Dishwasher User Manual


 
- 7 -
How to load the dishwasher
The illustration shows the machine loaded with five place
settings. Your own dishes are not likely to be identical to
this load, but if you follow the advice below we are sure
you will be pleased with the results.
• Always place glasses, cups and bowls upside down.
• Incline deep dishes (soup plates etc.) so that the
water can run off when drying.
• Make sure that the dishes do not rest against each
other. This is particularly important in regard to the
cutlery basket - nested spoons, etc. simply cannot be
properly washed. The water must reach all the soiled
surfaces.
• Make sure that cutlery with slender handles and other
items do not protrude through the openings in the
basket and prevent the spray arm from rotating.
• Never put silver and stainless steel objects together.
When these metals come into contact with each other
a chemical reaction occurs which stains the silver.
• China with a pattern applied on top of the glaze may
not be suitable for machine washing as the colours
may fade and lose their lustre. The same applies to
cutlery with wooden or plastic handles.
Make sure you always buy articles that are dish-
washer proof.
• Not all plastic articles are machine washable. If you
are in doubt as to whether your plasticware can be
machine washed, we suggest you check by washing
a single item or else wash them by hand.
• Aluminium becomes dull and tarnished when machine
washed. The machine gets it clean, but at the expense
of its appearance.
• When washing delicate items, select the lower wash
temperature.
• Substances such as ketchup containing strong
colouring agents can cause temporary discolouration
in the machine.
Do not place sharp knives with their points
upwards. It is much safer to lay them hori-
zontally in the basket.
1
Instruction for test centres
Test standard: EN 50242
Rated capacity: 5 place settings
Loading of rack: According to figure 1
Test program: Normal 65° C
Detergent (IEC type B): 15 gram in the dispenser
Rinse aid (typ III): Setting medium
Feed water pressure: Minimum 0,8 bar, maximum 10 bar
Waste water outlet: Install according to figure 2
The salt container and rinse aid dispenser shall be filled in accordance with the instruction manual. Before conducting
the measurements the dishwasher shall be operated for one or two complete cycles using detergent and a clean load.
2