Filter
Top Products
5. PROGRAMME SELECTION button
To select the required programme, press this button
until the number corresponding to the chosen pro-
gramme appears in the digital display (4) (see wash
programme guide). To start the programme, simply
close the dishwasher door. A long audible signal
(about one second) informs you that the programme
is starting.
If you open the door whilst the programme is in opera-
tion in the digital display appears the remaining time
(in minutes) to the end of the washing cycle.
6. Indicator Light
This pilot light comes on when programmes 2, 3, 5,
and 8 are selected to remind you that these pro-
grammes require a small amount of detergent to be
added in the Super Intensity Dispenser «SID» located
in the centre of the upper basket. Follow the instruc-
tions given in the «Washing programme» chart.
Attention: if the «half load» (7) option is selected the
SID light will illuminate only with programme 2
(Intensive 70°C).
7. Half load UPPER/LOWER pushbutton
By pressing this button, washing can be confined to a
single basket instead of both. Depress the button until
the indicator light corresponding to the basket selected
illuminates.
This is very useful and economical when only a few
dishes need washing.
Remember to load all the dishes into the basket
selected.
Do however follow the instructions given in the
section «Loading your machine».
8. ECO DRY button
By pressing this button the last rinse and the hot air
drying cycle will be shorten, making a considerable
energy saving.
The corresponding indicator light comes on.
9. NO DRY button
By pressing this button the last rinse water will be cold
and hot air drying cycle will be omitted.
The corresponding pilot light comes on.
If both the ECO DRY and NO DRY indicator lights
are out, the full drying cycle will be carried out.
10. DELAY START button
The start of the programme can be delayed by a mini-
mum of 1 hour, up to a maximum 9 hours.
How to set DELAY START
By pressing the button, will appear on the digital
display; this means that you have delayed the start of
the programme by 1 hour.
By pressing the button repeatedly, you can delay the
start of the programme up to a maximum of 9 hours.
By pressing the button one more time you go back to
the programme setting.
Press the button again to select the number of hours
by which you wish to delay the programme start, up to
a maximum of 9.
Close the dishwasher door to start the countdown: a
long audible signal (about one second) informs you that
the function is active. If you open the door again you will
see, in the display (4), how long there is to go (in hours)
before the programme starts. A flashing «H» in the digi-
tal display means that the delayed start function has
been activated. Opening the door has no effect on a
countdown which has already been started.
11. CANCEL / programme change button
If you wish to cancel a programme which is already
running or a setting which has just been made, press
this button for about two seconds until the short
«instruction accepted» signal is heard. In the digital
display will appear to indicate that the dishwasher
has been reset and that a new programme and new
options can be selected.
PPC27GB
7