Filter
Top Products
This dishwasher is designed to be fitted under a kitchen
counter or worksurface.
It is essential that the recess dimensions indicated in the
diagram are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hose and
power supply cable pass through.
The recess height may be anywhere between 820 and
880 mm from the floor as the dishwasher incorporates
adjustable feet (max 60 mm).
A distance of 2 mm should be allowed between the top
of the dishwasher and the counter top.
Adjusting the height of the
appliance
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. The rear foot is adjusted by turning the screw in
the middle of the front kick plate to the left or
right.
A pad is supplied for the rear foot to make sliding the
appliance in and out of the recess easier.
To fit the pad, press it onto the rear foot.
If required, the dimensions of this pads can be reduced
by breaking it where marked.
Good levelling is essential for correct closure and
sealing of the door. When the appliance is correctly
levelled, the door will not catch on the levelling spacers,
either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
Building-in
27
PFI20UK
575
max
600
596
555
max
600
+
-
550
max
596
820
880
÷
818
878
÷
II64
II52
IN11
IN12