Zanussi ZU 7155 Refrigerator User Manual


 
18
The appliance is equipped with adjustable support
feet. To adapt the appliance to the height of the instal-
lation area (max 870 mm), screw in, or screw out the
feet situated to the four bottom corners.
Separate parts A, B, C, D as shown in the figure.
Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
Fix cover (C) on guide (A) until it clips into place.
Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door and
mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm at 8
mm from the outer edge of the door. Place the small
square on the guide again and fix it with the screws
supplied.
S.I.006
30
PR266
A
B
C
D
20mm
A
50mm
PR166
PR33/2
C
A
8mm
PR167
A
B