10
Zanussi 818 15 02--02/5
Something Not Working
Before contacting your local Service Force Centre check the following points:
Symptom Solution
The temperature is too high inside the
freezer.
Set a lower temperature.
Make sure that the door is completely closed and that the
rubber gasket is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
The temperatur e is too low inside the
freezer.
Set a higher temperature.
Fast Freeze could have been switched on.
Too much frost and ice are produced. Make sure that the door is completely closed and that the
rubber gasket is complete and clean.
Set a higher temperature.
The compressor operates continuously. Set a higher temperature.
Make sure that the door is completely closed and that the
rubber gasket is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
The power plug is not properly connected.
The fuse has blown.
The cabinet is not switched on.
Power does not reach the cabinet. (Try connecting another
electrical device to the power outlet.)
Power failure Do not unnecessarily open the cabinet, except when the power
outage seems to be long, in which case t he food products
should be moved to another cabinet that works. See t he chapter
"Hints and Tips".
Noise See "Normal operating Sounds" in chapter
Hints and Tips.
The freezer door will not open Has door just been opened? If so leave for few minutes to allow
the air pressure to equalise.
If after above checks there is still a fault call your local Service Force Centre.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge
if the fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service calls.