Filter
Top Products
Zenith Hydro Tap Installation and Operating Instructions - 81467 - February 2005 Page 13 of 20
Symptom Possible Cause Solution
No LED display, no tap head
lights or, no water when tap
levers are operated.
No water flow.
Slow water recovery after
use.
Water not hot.
Water not chilled.
No power.
Plug is not located in power
socket.
Tap loom is not connected to
HydroTap unit.
Possible internal fault.
Program in OFF cycle
Water supply isolated.
Water supply not connected.
Power supply not connected.
Tap loom is not connected to
HydroTap unit.
Possible internal fault.
Program in OFF cycle.
Filter may require replacement.
Unit in Sleep Mode.
Unit has just come out of OFF
cycle.
Possible internal fault.
Excessive use, unit refilling or
chilling down to temperature.
Possible internal fault.
Check power supply.
Ensure power plug is correctly fitted and switch is
turned ON.
Check loom connection.
Contact local Zenith service provider.
Check LCD for information.
Check water supply is on.
Check to ensure plumbing connecting is made.
Check power plug is correctly fitted and switch is
turned on.
Check for loom connection
Contact local Zenith service provider.
Check LCD for information.
Check filter usage on LCD screen, if “filter
change” is displayed follow instructions
on page 13.
Touch Hot lever and wait for Red LED to stop
flashing.
Wait for Red LED to stop flashing.
Contact local Zenith service provider.
Wait for Blue LED to stop flashing.
Contact local Zenith service provider.
Trouble Shooting