Zephyr EGL-E36AS Ventilation Hood User Manual


 
13
www.zephyronline.com
12. Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service panel
before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC
SHOCK, THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST UNDER
NO CIRCUMSTANCES BE CUT OR REMOVED.
Failure to do so can result in death or electrical
shock.
Remove the Junction box cover and knockout and
install the conduit connector (cULUS listed) in junction
box cover.
Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordi-
nances, in 1/2" conduit from service panel to junction
box.
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
Close junction box cover.
13.For Ductless (recirculating) installations
Install one charcoal filter (available as an extra kit).
14.Check all light bulbs to make sure they are secure
in their sockets.
Turn power on in service panel.
Check lights and blower operation.
15.Install filter.
If range hood does not operate:
Check that the circuit breaker is not tripped or the
house fuse blown.
Disconnect power supply. Check that wiring is
correct.