A SERVICE OF

logo

Installing and Operating the Module 3 - 7
Setting Dip Switch SW2
The SW2 dip switch on the 10BASE-FL Module contains 8 dip switches.
Switches 7 and 8 are not functional. The remaining switches allow you to:
Enable or disable each of the ports
Assign the module to a channel
Table 3-3 lists the functions and settings for switches 1 through 4. For a
definition of each dip switch function, refer to the Configuring the Module
section in this chapter..
Table 3-3. Dip Switch SW2 Settings for Switches 1 to 4
Switch Function Factory Default
1 Enable/Disable port 1 Enable (On)
2 Enable/Disable port 2 Enable (On)
3 Enable/Disable port 3 Enable (On)
4 Enable/Disable port 4 Enable (On)