A SERVICE OF

logo

Installing the PathBuilder S21x Switch Hardware 2-5
Cabling the PathBuilder S21x Switch
Cabling the PathBuilder S21x Switch
Introduction
After unpacking the PathBuilder S21x switch, you can connect the cables to
complete the hardware installation.
PathBuilder S21x
Switch Rear Panel
Figure 2-3 illustrates the rear panel of the PathBuilder S21x switch, optional
daughtercards, and the locations of cables that must be connected.
Caution
Connectors showing this symbol must not be connected to Published Switched
Telephone Networks (PSTN).
Mise en Garde
Les connecteurs marqués de ce symbole ne doivent pas être connectés au réseau
téléphonique commuté public (RTCP).
Vorsicht
Stecker mit diesem Symbol dürfen nicht an das öffentliche Telefonnetz (PSTN)
angeschlossen werden.