Windows 2000 Installation
1. Connect the rectangular end of the USB cable
into the USB host port of your computer, and
the square end into the USB port of your
network adapter. Windows 2000 will
automatically detect the device. Click Next
to continue.
2. Select Search for a suitable driver for my
device (recommended) and click Next.
3. Select Specify a location and click Next.
4. Insert the device driver into your CD-ROM
drive. Click Browse, direct Windows 2000
to the location where the driver stored and
click OK.
5. Click Next. Windows 2000 will start
copying necessary files onto your system.
6. Click Finish to complete the software
installation.
7. To verify if your network adapter exists in
your computer and well enabled, you can
perform the following steps.
8. Go to Start, Settings, Control Panel,
Hardware and then Device Manager.
9. Click Intelligent ISDN Drivers and Network
adapters to expand. If Intelligent CAPI 2.0
driver, Intelligent USB adapter and
Intelligent ISDN WAN miniport are found,
that means your network adapter exists and
enabled. If not, consult your distributor for
technical support.
- 7 -
