2 –Pump 18-Station Controllers Chapter 4: Operation 24 of 44
The following table explains the status represented by each icon on the “Station Status”
screen.
Icon Label Description
Offline Station is not enabled. The controller ignores any demands or
alarms.
Ready Station is enabled and idle (full).
Demand Station requires material.
Convey Station is being loaded with material.
Dry Air
Convey
Air to convey material is coming from dry air source, rather than
ambient air.
Unload Station is dumping material into its receiver.
Priority Station is in priority convey mode. Its pump will be temporarily
dedicated to filling it as soon as possible.
**Icon will flash when Priority Convey is active.
Alarm Station is in alarm.
Critical Station is in critical alarm. The controller has disabled the station
until the alarm is cleared.
Purge Air is being drawn through material lines.
Additional basic information about each station (convey time, dump delay, and pump
assignment) is available at the “Station Operator” screen. See page 27 for details.
Detailed configuration settings for each station are available at the “Station Setup” screen.
See page 35 for details about each of these settings.
