1. Assemble the handle tube to the leg tubes using the two
1/4" x 2" carriage bolts and nylon wing nuts. See fi gure 1.
2. Assemble the Control Cable to the handle tube using a
1/4" x 2" carriage bolt and nylon wing nut. See fi gure 1.
NYLON
WING NUT
1/4" x 2"
CARRIAGE
BOLT
The following safety precautions are suggested. This
broadcast spreader is designed, engineered and tested to
offer reasonably safe and effective service, provided it is
operated in strict accordance with these instructions. Failure
to do so may result in personal injury. Always observe the
1. Do not allow anyone to operate the spreader without
2. Do not permit children to operate the spreader.
3. Wear eye and hand protection when handling and when
applying lawn or garden chemicals.
4. Read the label instructions and cautions for handling
and applying the chemicals purchased for spreading.
5. Keep all nuts, bolts and screws tight to be sure equipment
is in safe working condition.
6. Follow maintenance and lubrication instructions as
1. Pivot the handle up into the operating position and
tighten the two wing nuts.
2. This unit will cover a 4 to 8 foot wide area depending
on the material used and walking the speed of user.
3. Check the listing on the material package or in the
Recommended Spreader Settings instruction sheet for
the proper spreader setting and application rate.
Before fi lling the spreader, push the control lever to the
5. Move spreader onto a fl at surface - either a walk or a
.
Slide the Adjustable Stop to the desired setting.
Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
Always place control lever in the "OFF" position
while fi lling spreader and when stopping or turning to prevent
excess fertilizer from being released.
1. To avoid misses or striping, make each pass about 5 feet
from the previous one so some overlapping of spread
2. For easiest application, spread across the shortest
edges of lawn fi rst, making two "header" strips for a
turning area, and then spreading between the header
3. If lawn is odd shaped, spread a border around the edges
and then spread between the border. See fi gure 2.
4. Keep wheel approximately 4 feet from any area you do
Be careful when using spreader around
ornamental plants because weed controls can damage
1. Always empty spreader after each use, storing leftover
material in it's original bag.
2. Wash the spreader and dry thoroughly after each
3. Apply a few drops of oil to all moving parts.
4. Tighten all nuts and screws before each use.
ADJUSTING THE FLOW RATE SETTING
1. Loosen the wing nut that fastens the control to the
2. Slide the Adjustable stop to the desired setting and
