·Pump cannot be operated without oil
·The operating voltage is between 110V to 115V, 60Hz. You must use a grounded outlet.
·When unplugging the pump, pull the plug. Don’t unplug unit by pulling on the wire.
·Keep electrical cord free from all shop equipment, and do not let pump hang by power cord
·Don’t use damaged plug or outlet.
·Don’t plug or pull out the plug with wet hands.
·Don’t plug unit in, unplug unit or use switch if there are any flammable or explosive gases
present.
·Always Unplug unit before disassembling.
6. Installation
·When in use, the pump should be horizontal and should be positioned where it is dry,
ventilated and free of dust and other contaminants.
·In order to ensure proper air flow, you must maintain a clearance around the pump of at least
10 cm (4 inches)
·To permanently mount the vacuum pump, remove the rubber pads from the bottom of the
base, and use the existing threaded holes to mount unit. Mount with ST4.2 screws. When
permanently mounting this pump, be sure to maintain proper clearances around the unit,
especially at the air intake in the end of the vane shell.
·If a special electromagnetic valve is needed, it can be installed on the gas inlet
