Change back to RF control (ACTIVATE RF CONTROl)
If you want to reactivate the RF control, follow the instructions below:
Step 1:
Enter pairing mode – Press and hold the OK and MENU
keys simultaneously for three seconds until all four mode
keys flash red twice and you hear two short beeps to
confirm you are in programming mode.
Step 2:
Enter 9 6 9 – Using the numeric keypad on your remote,
enter 9 6 9. The mode key will flash red twice to confirm it’s
in pairing mode. The AT&T mode key on the Point Anywhere
RF Remote Control will flash red and beep twice to confirm
activation of RF control.
NOTE: If the programming is interrupted or inactive for
more than 10 seconds, the mode key will give a long red
flash and you will hear a long beep. This indicates the Point
Anywhere RF Remote Control has left the programming
mode and returned to normal operation without saving
any changes. You will have to start over again.
Assign volume control for AT&T and DVD modes
By default, the volume controls are automatically assigned to control your TV
unless an audio device is programmed into the remote control, which then sets
the volume keys to control the audio device. The instructions below demonstrate
how the volume controls can be set to control the volume and mute function for
the device of your choice.
NOTE: This allows you to manually assign volume control to the preferred device.
Step 1:
Press the AT&T mode key.
Step 2:
Enter pairing mode – Press and hold the OK and MENU
keys simultaneously for three seconds until all four mode
keys flash red twice and you hear two short beeps to
confirm you are in programming mode.
Step 3:
Press VOLUME UP – Press the VOLUME UP key. The AT&T mode key
will blink red once.
Step 4:
Select the device you wish to use for volume control –
Press the selected mode key of the device you wish to use
for volume control. The selected mode key will flash red
twice and you will hear two short beeps to indicate the
volume control has been successful assigned.
Reassign Channel Lock to another mode, not AT&T mode key
Step 1:
Press the AT&T mode key.
Step 2:
Enter pairing mode – Press and hold the OK and MENU
keys simultaneously for three seconds until all four mode
keys flash red twice and you hear two short beeps to
confirm you are in programming mode.
Step 3:
Enter 9 7 3 – Using the numeric keypad on
the remote, enter 9 7 3. The AT&T mode key
will flash red twice.
Step 4:
Press CHANNEL UP – Press the CHANNEL UP
key. The AT&T mode key will flash red once.
Step 5:
Select the device you wish to use for channel control –
Press the selected mode key of the device you wish to use
for channel control. The selected mode key will flash red
twice and you will hear two short beeps to indicate the
channel control is set.
12 13
