7/9/2008
RS-603 REV A.
12
FEATURE “II” PROGRAMMING:
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in the ‘OFF’ position.
2 Push the Programming switch 2 times and hold it until the LED turns on and (*) two chirps with a long chirp is heard;
then release the Programming switch. You are now in the feature ‘II’ programming mode.
3 Press and release the desired transmitter button icon corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1.
Gasoline Engine Diesel Engine and 10
seconds warn-up
timer
Diesel Engine and 15
seconds warn-up
timer
Diesel Engine and 20
seconds warn-up
timer
2.
20 minutes run time 10 minutes run time 30 minutes run time 5 minutes run time
3.
+
H2/2 White wire =
Constant Parking
Light Output
H2/2 White wire =
Flash Parking Light
Output
4.
+
Door Lock before
start
Door Lock after start
Door Lock before &
after start
* This is
the preferred setting
when using the
optional XT-11 single
button remote
Without this
feature
5.
0.8-second Door lock
& Unlock.
3.5-second Door
Lock & Unlock.
0.8 second lock, 0.35
second unlock
0.8 second dbl
lock,0.8 second dbl
unlock
Five chirps= 0.8 second lock, dbl 0.8 second unlock
Six chirps= dbl 0.8 second lock, 0.8 second unlock
Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
FEATURE “III” PROGRAMMING:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in the ‘OFF’ position.
2. Push the Programming switch 3 times and hold it until the LED turns on and (*) three chirps with a long chirp is
heard; then release the Programming switch. You are now in the feature ‘III’ programming mode.
4. Press and release the desired transmitter button icon corresponding to the feature you want to program.
(*) The Horn must be connected to hear the programming chirps.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1.
Tachometer checking
type.
Voltage checking type Timer checking type
DBI TACH **
DATA ONLY !!
2.
RPM learning
Start Timer:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4 chirps),
1.4-second (5 chirps), 1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps), 4.0-second (10 chirps),
3.
Low check level Hi check level
4.
+
Second Accessory
H3/9 Blue/Black
Second Start
H3/9 Blue/Black
5. +
+ 50 RPM
DBI ONLY
No RPM learning
6. +
- 50 RPM
DBI ONLY
No RPM Learning or < 50RPM
