P. 24 User Guide
If the vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (see “Ready Mode Option” in this Guide); at the last step, the
TRUNK button is pressed instead of the other buttons.
Please note that the horn will honk once and that the OEM-style alarm will be armed if the
Idle Mode option is enabled.
Note: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If the vehicle has an automatic transmission, proceed as follows to set the system to Turbo
Mode:
1) With the engine running, make sure to release the brake pedal and press the LOCK, UNLOCK
or START/STOP button on the transmitter until the parking lights come ON.
2) Remove the ignition key from the ignition switch.
The engine will continue running.
3) Exit the vehicle and close all doors, hood and trunk.
4) Press the TRUNK button; this will lock the doors, arm the OEM-style alarm (if
configured|) and confirm that the vehicle is in Turbo Mode.
5) The engine will shut down after 60 seconds.
If the vehicle has a manual transmission, follow all steps of the Ready Mode routine (see
“Ready Mode Option” in this Guide) to activate Turbo Mode. At the last step, press either:
1) LOCK to lock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
The OEM-style alarm and starter kill (if configured) will be armed.
2) UNLOCK to unlock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
3) START/STOP to shut down the engine without affecting the doors.
Note: The vehicle will enter Ready Mode once the engine run time expires.
Cold Weather Mode
If the vehicle has a manual transmission, Ready mode should be set before entering Cold
Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3
minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends after
24 hours (or 12 starts).
To enter Cold Weather Mode:
• Press and release the
AUX button.
The
LOCK button on the transmitter will light up.
• While the
LOCK button is still lit up, press the START/STOP button.
The transmitter will beep once.
• Keep pressing the
START/STOP button until the transmitter beeps twice.
• Release the
START/STOP button.
Its LED will flash quickly.
The parking lights will flash 3 times.
To exit Cold Weather Mode, do any one of the following actions:
• Open the hood.
