3. Physical Installation
• A : Led-wall out
-DVI.
- Data outpu t source to drive ILite / DLite display wall.
• B : Power switch
- The power ON/OFF switch is provide on the rear side of the Digitizer.
o
Switch pressed to 1 = the unit starts.
o
Switch pressed to 0 = unit totally switched off.
• C : Power input
- Autoranging from 90 to 260 VAC / 1 30 Watt.
• D : Loop in
- From previous Digitizer.
- Panel Link M DR26.
- Used for c haining multiple digitizer to increase the num ber of usable input sources.
• E : Loop out
- To next Digitizer.
- Panel Link M DR26.
- Used for c haining multiple digitizer to increase the num ber of usable input sources.
• F : Retractable dust filter
- The fan intake grill of the Digitizer ha s a retractable dust filter. This filter can be r etracted from the back o f the unit. Check
the filter for g ood functionality on a r egular basis. Never allow this filter to become blocked up and never operate the unit
without a good working air filter in place.
• G : RS232 in
- Direct master.
- RS232 input port for com munic ation links with local PC.
• H : Reserved communication p ort
• I : RS232 out
- RS232 output port for communication links from a PC or to other Digitizers in chain.
• J : Ethernet LAN connector
- For future use.
• K : Monitor out
- RGBHV (DD15)
o
Red (75 Ohm output impedance)
o
Default: 0,7 Vpp
o
Adjustable: 0,5 Vpp to 1,0 Vpp via user interface
o
Green (75 Ohm output impedance)
o
Default: 0,7 Vpp
o
Adjustable: 0,5 Vpp to 1,0 Vpp via user interface
o
Blue (75 Ohm ou tput impedance)
o
Default: 0,7 Vpp
o
Adjustable: 0,5 Vpp to 1,0 Vpp via user interface
- H (TTL output)
o
Set TTL-Level polarity via user interface.
- V (TTL output)
o
Set TTL-Level polarity via user interface.
The “Led-wall out” connector is property to Barco LED walls. Do not connect to other devices than a Barco
LED wall.
3.3 Removing and inserting a D320 inpu t module
There is no need to switch off the D320 Digitizer to remove or insert an input module. The input
modules are
hot swappa ble.
8 R5976388 D320 DIGITIZER 05112002
