39331/39341 pg 4
1201 Rev. B
WARNING
Rear of Vehicle
Seat
Seat Legs
Slide Lower Rear Pin on
Seat into top hole in
Floor Mounting Brackets
Seat
Cotter Pin
Failure to install the Cotter Pin may result in the seat moving off the Front Brackets which could result in serious injury to you and others.
Floor Mounting
Bracket
Step Three
Seat Installation
Orient the Seat, with the Legs on the bottom of the seat facing
the rear of the vehicle. Fold the Seat back down into the closed
position. Place Seat in the vehicle.
Locate the two (2) pins in each front corner of the seat
cushion. Slide the lower, rear pin on one side into the top hole
in the Floor Mounting Bracket on that side. Push the pin as far
as possible into the hole and tip the seat down to slide the pin
on the other side into the Mounting Bracket. Once the pins are
securely in the brackets on both sides, install a Cotter Pin on
each pin. Make sure that the Cotter Pins are securely in the
grooves in the pins.
Adjust the height of the Adjustable Seat Legs to assure the seat back locks securely into the Lock Down Brackets. If the Seat does not lock in place, it may
tilt forward unexpectedly which could result in serious injury to you and others.
WARNING
Rear of Vehicle
Lock Down
Bracket
Step Four
Lock Down Bracket Adjustment
Place the bottom of the seat down on the floor of the vehicle.
Raise the seat back into the sitting position and check the
alignment of the Lock Down Pin on the seat with the Lock Down
Bracket. If the pin locks into the bracket, but the seat wiggles,
rotate the bracket toward the rear of the vehicle. If the pin does
not engage completely into the bracket, rotate the bracket toward
the front of the vehicle. Once the seat locks securely into position,
tighten the bolts on the Lock Down Bracket.
The legs on the rear of the seat may be adjusted up or down to
fine tune the adjustment of the seat. Turn the legs clockwise or
counterclockwise to raise or lower the seat.
Seat Back
Lock Down
Bracket
Lock Pin
Adjust position of bracket to
make sure seat locks
securely into Lock Down
Bracket
Front
