Setting Up Polling Sending
8-19
8
Using Polling
CF-PL Facsimile Guide_USEN HT1-2188-000-V.1.0
NOTE
• You can adjust the resolution, contrast, and document type for scanning. (See
“Adjusting the Scan Settings,” on p. 3-4.)
• You can also specify a sender’s name with [TTI Selector]. (See “Selecting a
Sender’s Name,” on p. 3-6.)
2
Open all three one-touch speed dialing panels.
3
Press [Advanced Communication] ➞ press [Set] twice.
4
Enter the two digit number of the polling box using the
numeric keys ➞ press [Set].
5
If you want to select a sender’s name, press [TTI Selector] ➞
[
▼] or [▲] until you see the sender’s name you want to use.
If you do not want to select a sender’s name, proceed to the next step.
6
Press [Set].
The document is scanned into the polling box.
NOTE
If another party polls your machine to receive a document stored in your polling
box, the document is sent if the following conditions are met:
- If a subaddress and a password was entered when you created the polling box,
the subaddress and password attached to the other party’s polling request must
match the subaddress and the password of the polling box.
- The password setting is optional. However, if you have registered a password for
the polling box, the other party’s polling request must contain a matching
password.
- If no password is registered for the document in the polling box, and the other
party’s polling request contains a password, then the document will not be sent.
➞
➞
Advanced
Communication
Set
4
1
7
5
2
8
6
3
9
0
Set
TTI
Selector
Set
Set
