A SERVICE OF

logo

Open as PDF
next previous
1
1-11 Connecting network cable to the ColorPASS
Ethernet connection
For connecting to Ethernet, the ColorPASS supports Unshielded Twisted Pair (UTP)
cabling, defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the ColorPASS.
NOTE: The 100BaseT type supported by the ColorPASS is 100BaseTX, also known as
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used to refer to 100BaseTX.
TO CONNECT TO THE ETHERNET BOARD:
• Connect the network cable to the RJ-45 connector on the back of the ColorPASS.
A Category 5 unshielded twisted pair cable network cable must be used for 100BaseT.