3. Wiring.
•
Route wires (29) using either method shown(Fig. 3-5).
• Wires along boom are held in place with
wire clips.
– Wires can be slipped under the wire clips
already in place.
15
SAFE-T-BEAM
®
SYSTEM INSTALLATION
FOR HELP-1.800.929.3667 OR OVERHEADDOOR.COM
3
NOTE: The operator will not close the door
automatically unless the Safe-T-Beam
®
System is
installed.
1. Mounting brackets.
• Mark both sides of garage door frame or wall 5"
above floor.
(Fig. 3-1).
• Hold bracket against door frame or wall
.
– Check brackets extend out from wall far
enough that tongue of bracket is beyond door,
tracks or any door hardware.
– If not:
-“STB” bracket extensions are available
at local dealer.
-Blocks of wood, etc. may be substituted for
extensions.
• Center bracket on your mark (Fig. 3-2).
• Fasten each with 2 screws (44) (Fig. 3-2).
NOTE: Mounting brackets can be attached to the
floor using concrete anchors (not provided).
2. Mounting “STB” source and sensor.
• If garage has only one garage door.
– Determine which side of garage receives most
direct sunlight (Fig. 3-4).
– Red LED should always be on sunny side
whenever possible (Fig. 3-4).
• For multiple doors.
– Preventing crossed signals is critical.
– Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 3-4).
NOTE: To help prevent interference from sun, “STB”
sensors (Green LED) may be placed further away from
the door opening where they will spend more time in
shadows.
• Slide source/sensor onto tongue of bracket until
it clicks into place (Fig. 3-3).
There should be no electrical power to the operator
while installing Safe-T-Beam System
®
wires. If you
have plugged in the power cord—UNPLUG IT NOW.
WARNING
FIG. 3-1 Mark door frame.
FIG. 3-2 Mount
brackets.
FIG. 3-3 Attaching
“STB’s” to brackets.
[
41
]
FIG. 3-5 “STB” wiring methods.
Sensor
Source
Red
Green
Power
Head
Sensor
Source
Red
Green
Power
Head
A
B
Dashed Line = striped wire
Solid Line = white wire
tongue
mark
center of
bracket
FIG. 3-4 “STB” locations.
#10"-16 x 1-1/4"
[
44
]