Cisco UC320W Quick Start Guide 3
Installation and Configuration
1 Connect a network cable from the WAN port of the Cisco UC320W to
your Internet Service or Internet access device.
2 Connect the supplied power cord to the POWER port and to a power
outlet. When the device is fully booted, the POWER/SYS light is steady
green.
3 Connect your computer to a LAN port on the Cisco UC320W. Do not
connect any devices to the LAN ports at this point. Your computer
will receive an IP address in the 192.168.10.x range.
NOTE:
• You may need to adjust your computer’s connecting settings to receive
an IP address dynamically.
• For best results, set the screen resolution to 1024x768 or higher.
4 Start a web browser. In the Address bar, enter the IP address of the
Cisco UC320W (default 192.168.10.1).
5 To log in, enter the username cisco and the password cisco.
Both the username and the password are case sensitive.
6 When prompted, enter a new username and password. Neither cisco
nor admin is valid.
7 Follow the instructions in the configuration utility to connect the
equipment and configure the system.
NOTE:
• If you are installing the Cisco UC320W in a network with another DHCP
server, complete the Network Topology step in the Getting Started
menu.
• For best results, complete the Upgrade Firmware task and accept all
available firmware updates.
Getting to Know the Cisco UC320W
1 LINE (FXO) Connect phone lines for traditional phone service.
2 PHONE (FXS) Connect an analog device, such as a phone.
3 WAN Connect to your broadband network access device or to an uplink port
on an Ethernet switch that is connected to the Internet.
4 LAN Connect IP phones and other network devices.
Power
12VDC
LAN (10/100/1000)
WAN
(10/100/1000)
2341
1234
LINE (FXO)
PHONE
(FXS)
LINE
OUT
LINE
IN
1 2 3 4 5 6 7
195714
