4
600766 Set of 4 Wheels
600768 2X Push-Connector Auto Drain-down (anti-freeze)
600770 Pump Water Seal Kit
600771 6 Valve Rebuild Kit
600780 5 head nozzle .008 w/ anti-drip adapter
600781 5 head nozzle .012 w/ anti-drip adapter
600782 Push-con Union
3. Safety Information
3.1 WARNING: Read through the entire instructions before attempting installation.
• Risk of electrical shock - This pump is supplied with a grounding conductor. To
reduce risk of electrical shock, connect only to a properly grounded, grounding type
receptacle.
• Have a qualified electrician wire the pump to a dedicated, fused circuit.
• Install pump on a flat, level, solid foundation. This pump is non-submersible.
3.2 CAUTIONS:
• Before operation replace non-vented oil reservoir cap with vented one which
you will find shipped in the electrical junction box. Failure to replace this cap
will void the warranty. Pump must be able to breathe. (See section 6.1 for more
details.)
• Pump warranty is voided by failure to use factory- supplied filter on water
supply! Water filter is installed on water INLET line! (See section 7.3 for more
details.)
• To reduce risk of electric shock, disconnect power before servicing this pump.
• Maximum design pressure is 800 PSI (55 bar) continuous. Under no circumstances
should the pressure be allowed to go higher than 1000 PSI (69 bar).
• This pump has been evaluated for use with water only. Do not use with any other
liquids.
• To reduce risk of electric shock, install with all electrical components well-grounded
and dry.
4. Grounding Instructions
• The pump should have a dedicated circuit
• The pump MUST BE GROUNDED! In the event of a malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least resistance
for the electric current. Install electrical hookup in accordance with all local codes and
ordinances. Warning: Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified electrician if you are in
doubt whether the pump is properly grounded. Never use a two-prong outlet or cut
off the third prong on the plug!
