A SERVICE OF

logo

Open as PDF
next previous
21
Maintenance
INSTALLATION
|
Uninstallation Existing Toilet seat
|
Installation the Product
Uninstallation Existing Toilet Seat
1. Remove the xing nuts of the existing seat
and separate the existing toilet seat
1
and
the seat cover
2
.
Keeptheremovedseatandtheremovedseatcoverinashaded
place.
Installation the Product
1. Turn o the main water supply valve
1
on the water
pipe and separate the existing water tank hose
2
.
2. Connect the rubber packing, T-shaped connector, and
water tank hose to the existing main water supply
pipe. Please connect the bidet hose to the T-shaped
connector.
Pleaseinserttherubberpackingbetweenthewaterpipeandthe
T-shapedconnectionpipenecessarily.
FirmlyrotatethenutsbelowandontopoftheT-shapedconnectortotheendclockwise.
3. Please assemble by turning the MF lter on the lter
holder to the arrow direction as the gure.
Ifthelterisassembledloosely,thebidetmaynotfunction
normally.Firmlyconnectthelter.
4. Please connect the lter assembled the lter holder in
the rear of the product and x using the lter clip.
Checkifthelterclipisinsertedcorrectly.Whenthemainwater
supplyvalveisopened,ifthelterclipislooselytted,asthelter
holdermaybeseparated,thewatermaysplashanditmaycause
injury.
Itisnotpossibletoseparatetheltercliponceitisttedtotheproduct.
Whentheproblemoccursduetothelterclip,calltheservicecenter.
1021214 BA08-A 사용설명서_미주향_(09.06.10)_003.indd 21 2009.6.10 6:17:0 PM