Crown International
1718 W. Mishawka Rd.
Elkhart, IN 46517-9439
TEL: 574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com
7/05
Crown’s Three-Year, No-Fault, Fully Transferable Warranty
Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown IQ com-
ponent—an unsurpassed industry standard. With this unprecedented No-Fault protection, your
new Crown IQ component is warranted to meet or exceed original specifi cations for the fi rst three
years of ownership. During this time, if your unit fails, or does not perform to original specifi ca-
tions, it will be repaired or replaced at our expense. About the only things not covered by this
warranty are those losses normally covered by insurance and those cuased by intentional abuse.
And the coverage is transferable, should you sell your unit.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside
of the USA, please contact your authorized Crown distributor for warranty information or call
574-294-8200.
Specifi cations subject to change without prior notice. Latest
information available at www.crownaudio.com and
iqaudiosystems.com.
Crown, Crown Audio and IQ are registered trademarks; PIP
and PIP2 are trademarks of Crown International. HiQnet is
a trademark of Harman International Industries, Inc. Other
trademarks are the property of their respective owners.
Printed in U.S.A.
© 2005 Crown Audio
®
, Inc.
IQ-PIP-USP3/CN SIgnal Flow Block Diagram
135809-2C
IQ-PIP-
USP3/CN
Balanced Audio Inputs:
Input Impedance: Nominally 20 k ohms
balanced, 10 k ohms unbalanced.
Maximum Input Level: + 20 dBu.
ADC Conversion: 18 bit, 312 µs latency.
Signal to Noise Ratio: 70 dB typical (A-
weighted, 20Hz-20kHz).
Crosstalk: > 60 dB @ 1kHz.
Common Mode Rejection (CMR): 50 dB typi-
cal.
Distortion: > 0.05% THD+N, 20Hz–20kHz.
Frequency Response: ± 0.5 dB, 20Hz–20kHz.
