Model # GK300-7M2
8
Connecting the Monitor to Camera - Note: you will need a small athead screwdriver
• Using the other end of the 50 foot wiring provided insert the end of the blue wire into the monitor ’s posi
tive camera connection (marked 1) and hold it there.
• Using the screwdriver push down on the small box above the hole the wire is inserted into, this should lock
the wire into place.
• Same end of the provided wire insert the end of the brown wire into the monitor ’s negative camera con
nection (marked 2) and hold it there.
• Using the screwdriver push down on the small box above the hole the wire is inserted into, this should lock
the wire into place.
• You camera and monitor should now be connected.
If the two wires are not already connected to your doorstrike:
• Using the instruction manual provided with your door strike, connect the positive and negative wires to
their proper terminals on the doorstrike.
Connecting electric doorstrike to Camera
• Using the instruction guide provided with your door strike, insert the positive and negative wires (not
included) into their proper place on the doorstrike.
• Loosen the screw to the camera’s doorstrike positive connection (marked 4) by turning the screw counter
clockwise.
Note: Do not fully unscrew the screw, just loosen it enough to t the horseshow end of the wires.
• Slide the Horseshoe end of the doorstrikes positive wire underneath the Screw Terminal on the camera’s
positive connection (connection 4).
• Tighten up the screw to lock the wire into place.
• Loosen the screw to the camera’s doorstrike negative connection (marked 3) by turning the screw counter
clockwise.
Note: Do not fully unscrew the screw, just loosen it enough to t the horseshow end of the wires.
• Slide the Horseshoe end of the doorstrikes negative wire underneath the Screw Terminal on the camera’s
negative connection (connection 3).
• Tighten up the screw to lock the wire into place.
• Your door strike should now be connected to the camera.
Note: When using this connection keep in mind that the door strike will be connected to the camera, which is
outside of your house – if the camera gets disconnected the electric door strike will get disconnected as well.
Connecting the Camera – Note: You will need a philips head screwdriver
• Unscrew the screw from the camera’s positive connection (marked 1).
Note: Do not fully unscrew the screw, just loosen it enough to t the horseshow end of the
50ft wires.
• Using the 50ft wiring provided slide the blue wire with the screw Mount on the end underneath the screw
to the Camera’s positive connection (marked 1).
• Screw the screw back into place, locking the blue wire underneath the power input.
• Unscrew the screw from the camera ’s negative connection (marked 2).
Note: Do not fully unscrew the screw, just loosen it enough to t the horseshow end of the
50ft wires.
• Using the same side of the 50 ft wire provided, slide the brown wire with the screw. Mount on the end
underneath the screw to the camera’s negative connection (marked 2).
• Screw the screw back into place, locking the brown wire in the camera output.
WIRING INSTRUCTIONS
