-7-
IV. INSTALLATION
1. Carefully remove the contents of the carton. You should nd (See Figure 1):
• Table
• Table Legs
• Hardware needed (screws and nuts)
• Fire Pit
• Burner Assembly
• Log Plate
• Five logs
• Flame Snuer
• One set of three ame adjustment rings (packaged inside the burners)
• Water Proof Cover
If components are missing, contact Duraame.
Figure3
How to attach the legs
2. Remove all these components from their packing. When handling the logs, take care not to
damage them. Keep packing materials away from children, as they could be a choking or
suocation hazard.
3. Check each component for shipping damage. If components are damaged, contact
Duraame.
4. Attach the legs to the table using supplied nuts. (see Figure 3).
5. Set the table on a level surface away from all ammable materials. For this appliance to
function properly, the table must be stable and level. If the surface on which the table is set is
uneven or unlevel, you must shim under the table legs. (see Figure 4 Step #1).
6. Carefully set the re pit into the center opening of the table. The outer rim of the bowl rests on
top of the inner rim of the table. (see Figure 4 Step #2).
7. Carefully lower the burner down onto the burner supports of the re pit. The burner is precisely
located by the two pins that protrude upward from the burner supports (see Figure 1). Take
care to see that the burner ts down over these pins. (see Figure 4 Step #3).
8. Carefully lower the log plate down over the burner. The three burners should protrude through
the three large holes in the log plate, and the log plate should rest on the three supports
located around the inside edge of the re pit. (see Figure 4 Step #4).
