1-6 NodeBuilder Debugger Errors (DBG)
DBG# Description
60
Cannot debug this device because it is not responding.
Please make sure that it is attached to the network and
powered on [DBG#60]
61
Cannot debug this device because it has not been
commissioned. Use LonMaker to commission it and try
again [DBG#61]
62
Network interface must be configured to run VNI
[DBG#62]
Use the control panel to select a VNI network image. The
name depends on which network interface you use. For the
PCLTA-20 use: PCL10VNI. Do not use NSIPCLTA or
PCC10L7.
63 Device not found in network database [DBG#63]
Remove the device from the NodeBuilder project treeview and
use the Device | Insert shortcut menu to select the device you
want to debug. You may have to re-drop the target device
shape with LonMaker.
64
Cannot debug this device because it is unconfigured.
Use the LonMaker Commission command to commission
it and try again [DBG#64]
65
Cannot debug this device because it is applicationless.
Use the LonMaker Load command to load the
application image and try again [DBG#65]
66
Cannot debug this device because it is hard-offline. Use
the LonMaker Device Manage command to put it online
and try again [DBG#66]
67
Cannot debug this device because it is soft-offline Either
reset it or use the LonMaker Device Manage command to
put it online [DBG#67]
68
Failed to write device memory. Please try again
[DBG#68]
69
Failed to read device memory. Please try again
[DBG#69]
70
A device being debugged either stopped communicating
or was deleted. The debug session will stop [DBG#70]
71
Device did not respond to Query Status command
[DBG#71]
Probably not a serious problem. Could be just a lost packet.
