8
1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.
2. THROTTLE HANDLE - FOR RIGHT HAND - Contains Stop Switch, Throttle Lockout, and Throttle Trigger.
3. THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is
prevented unless throttle trigger lockout lever is engaged.
4. STOP SWITCH - Mounted on top of the Throttle Trigger Housing. Move switch FORWARD to RUN, BACK to
STOP.
5. DRIVE SHAFT ASSEMBLY - Contains the Flexible Drive Cable.
6. SUPPORT HANDLE - FOR LEFT HAND - Adjustable, loop handle for proper cutting attitude and operator
comfort.
7. BLADES - Double reciprocating blades mounted to a blade support bar. Double sided blades, are capable of cut-
ting on either side.
8. GEAR HOUSING ASSEMBLY - Gear housing assembly xed straight extension.
9. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, depress gradually
for best operating technique.
10. BLADE COVER - Used to cover blade during transport and storage. Remove blade cover before using unit.
11. SPARK PLUG - Provides spark to ignite fuel mixture.
12. TOP GUARD - Protects arm from the hot engine.
13. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITH CATALYST -The mufer or
catalytic mufer controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of
carbon from leaving the mufer. Keep exhaust area clear of ammable debris.
14. FUEL TANK - Contains fuel and fuel lter.
15. FUEL TANK CAP - Covers and seals fuel tank opening.
16. RECOIL STARTER HANDLE - Pull handle slowly until starter engages, then quickly and rmly. When engine
starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
17. PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from
the carburetor. Pump purge bulb until fuel is visible and ows freely in the clear fuel tank return line. Pump purge
bulb an additional 4 or 5 times.
18. CHOKE CONTROL - Located on the air cleaner housing. Move the lever to Cold Start ( ) to close the choke
for Cold Starting. Move lever to Run ( ) position after engine res.
19. AIR CLEANER - Contains replaceable lter element.
Hand Guard
P/N 89018721560
P/N 89016021560
P/N X505001930
