20
s t a r t I n g c o l d e n g I n e
WARNING
When engine is started, conrm that there is not any abnormal
vibration or sound. If there is abnormal vibration or sound, ask
your DEALER to repair. After refueling tighten fuel cap rmly and
check for leakage. In case of fuel leakage repair before starting
operation since there is a danger of re.
1. Stop Switch
Move stop switch button (A) forward away from the STOP posi-
tion.
2. Choke
Move choke lever (B) to Cold Start Position ( ).
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and ows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Press the decompression device (E).
5. Recoil Starter
Lay the unit on a at area and keep movable attachment parts clear
of all obstacles. Hold unit rmly, and rapidly pull recoil starter
handle/rope (D) until engine res (or maximum ve [5] pulls).
NOTE
Starter handle : Use short pulls - only 1/2 - 2/3 of starter rope for
starting. Do not let starter rope snap back in.
Always hold the unit rmly.
6. Choke
After engine res (or 5 pulls), move choke lever back to Run
(
) position. Pull recoil starter starter handle/rope until engine
starts and runs. Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions 2 - 5.
7. Throttle Trigger
After engine warm-up, gradually depress throttle trigger to increase
engine RPM to operating speed.
A
B
C
D
E
D
