42
Cleaning the door glass panels
Clean the door glass panels thoroughly with a solution of water and washing
up liquid. Then dry them carefully
Putting the door glass panels back.
1.From above insert the door glass pan-
els at an angle into the door profile at
the bottom edge of the door one after
the other and lower them.
3 Insert the smaller panel first, then the
larger panel.
2.Take hold of the door trim (B) at each
side, position it on the inside edge of
the door and plug the door trim (B) into
the upper edge of the door
3 On the open side of the door trim (B)
there is a guide bar (C). This must be
pushedThis must be pushed between
the outer door panel and the guide cor-
ner (D).
The clip seal (E) must be snapped in.
