SelecType Options
Paper Size
Setting
A4
51
A5
35
B5
43
LT
47
LG 62
HLT
36
EXE 45
Paper Size Setting
GLG
57
I
GLT
45
I
F4
57
MONARCH
31
Cl0
41
DL
37
C5
38
Since the amount of RAM you reserve with this option is not
available for any other purpose, it is best to leave the setting at 0
until you see a SET FULL PRINT message. Then, increase the setting
in small increments until the error does not occur.
If FULL PRINT is set to the maximum value,
the
SET FULL PRINT
error does
not
occur. If an INSUFF MEMORY or PAGE BUFFER
FULL message appears, you must install optional memory. See
Appendix A for information on installing additional memory.
T-OFFSET
0
-64
to +63
You can use the T-OFFSET (top offset) option to make fine
adjustments in the position of
the
printing on the page. The setting is
in dots; each dot is
1/300th
of an inch (0.0846 mm) so you can use
this
option to raise or lower
the
printing on the page up to
approximately 1/5th of an inch (5 mm). The factory setting is 0.
SelecType
4-17
