A SERVICE OF

logo

Open as PDF
next previous
Testing the Printer
Now that your printer is fully assembled, you can use its built-in
self test function to see that the printer is working correctly before
you connect it to a computer. You should perform this test to
make sure that your printer was not damaged during shipping and
that the ribbon is correctly installed.
Before running the self test, you need to plug in the printer and
load paper.
Plugging in the printer
1.
Make sure that the printer is turned off. Then check the label
on the back of the printer to make sure the power rating
required by the printer matches that of your electrical outlet.
WARNING: If the rated voltage and your outlet voltage
do not match, contact your nearest Epson dealer for
assistance. Do not plug in the power cable.
Setting Up the Printer
1-15