A SERVICE OF

logo

Open as PDF
next previous
Programmer’s Guide, cont’d
ISS 408 Integration Seamless Switcher • Programmer’s Guide4-12
Command/response table for SIS commands (cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Vertical detail filter (RGB and component video inputs)
The vertical detail filter is available only for RGB and component video inputs.
The
X
2
value specified is the output to which the filtered input is switched.
The command (d) is case sensitive.
Set a specific filter value
X
2
*
X18
d
X
2
Dvz
X18
Set the vertical detail level.
Increment filter value
X
2
+d
X
2
Dvz
X18
Increase the vertical detail level.
Decrement filter value
X
2
-d
X
2
Dvz
X18
Decrease the vertical detail level.
View the vertical filter value
X
2
d
X18
Show the vertical detail level.
Detail filter (S-video and composite video inputs)
Composite and S-video inputs support a single detail filter only, rather than separate horizontal and
vertical filters. To apply a detail filter to the scaled output when the input is composite video or
S-video, use the same command as the horizontal filter (D) with the
X18
variable.
The
X
2
value specified is the output to which the filtered input is switched.
Set a specific filter value
X
2
*
X18
D
X
2
Dvz
X18
Set the detail filter level.
Increment filter value
X
2
+D
X
2
Dvz
X18
Increase the detail filter level.
Decrement filter value
X
2
-D
X
2
Dvz
X18
Decrease the detail filter level.
View the vertical filter value
X
2
D
X18
Show the detail filter level.
Auto Memories
Auto memories on 1M Aut
X
3
Set the ISS to apply auto
memories settings to all selected
inputs.
Auto memories off 0M Aut
X
3
Set the ISS to not apply auto
memories settings.
View auto memories status M
X
3
Auto memories is
X
3
(on or off)
for all inputs.
User presets
The
X
2
value specified is the output to which the input with the associated user preset is switched.
Save user preset
X
2
*
X19
, Spr
X
2
•
X19
Command code is comma. Save
the
X
2
outputs settings as preset
X19
.
Recall user preset
X
2
*
X19
. Rpr
X
2
•
X19
Command code is period. Recall
preset
X19
settings for
X
2
output.
Freeze
Enable
X
2
*1F
X
2
Frz1 Output a “frozen” video image.
Disable
X
2
*0F
X
2
Frz0 Turn off freeze (output motion
video).
View the freeze status
X
2
F
X
3
Show the freeze status.
Example:
X
2
F0 Freeze mode is off.
Test pattern
Select test pattern for an output
X21
*
X22
JTst
X21
*
X22
Select a test pattern for the
X21
output(s).
View test pattern J
X21
*
X22
Show the test pattern.
Example: j 3*002 Crosshatch test pattern was
selected for both outputs.