Refer also to the MPX Plus 866 A User’s Manual at www.extron.com.
Refer also to the MPX Plus 866 A User’s Manual at www.extron.com.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
IP setup
Set IP address
EX1#
CI
}
Ipi
X1#]
Read IP address
E
CI
} X1#]
Set subnet mask
EX1#
CS
}
Ips
X1#]
Read subnet mask
E
CS
} X1#]
Set gateway IP address
EX1#
CG
}
Ipg
X1#]
Read gateway IP address
E
CG
} X1#]
Set DHCP on or off
EX1$
DH
}
Idh
X1$]
Read DHCP on/off status
E
DH
} X1$]
Set verbose mode
EX1%
CV
}
Vrb
X1%]
Read verbose mode
E
CV
} X1%]
Congure current port timeout
E
0*
X1^
TC
}
Pti0*
X1^]
Read current port timeout
E
0TC
} X1^]
Congure global IP port timeout
E
1*
X1^
TC
}
Pti1*
X1^]
Read global IP port timeout
E
1TC
} X1^]
N
X1#
= IP address ###.###.###.###
X1$
= DHCP 0 =1 off, 1 = on
X1%
= Verbose mode 0 = clear/none (default for Telnet connection)
1 = verbose mode (default for RS-232/RS-422 connection)
2 = tagged responses for queries
3 = verbose mode and tagged for queries
X1^
= Port timeout interval 1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
Installing and Starting the Control Program
Several useful Windows
®
-based programs are available on the
Extron Software Products CD-ROM that is included with the
switcher, including the DSP Congurator program and the
Matrix Switchers Control Program. These programs are also
available on the Extron Web site, www.extron.com.
The DSP Congurator program is required for full operation of
most of the switcher's DSP functions and to save partial presets.
It also provides some limited control of the switcher's non-DSP
functions. Refer to the MPX Plus, 866 A User's Manual and the
program Help le for more information.
The Matrix Switchers Control Program is another way to
operate the switcher's more basic, non-DSP, functions.
Run either program on a PC connected to either of the
switcher’s serial ports or the Ethernet port. See
l
,
m
, and
o
,
on pages 2-5, for connection information. The program must be
installed on a Windows-based computer and cannot be run from
the CD.
N
For details on operating the programs, refer to the
MPX Plus 866 A User's Manual, chapter 5, “Matrix
Software”.
Installing the programs
1. Insert the CD-ROM into the drive. The installation
program should start automatically.
The Extron software CD window appears.
N
If the installation program does not self-start, run
Launch.exe from the CD.
2. Click the Software tab.
MPX Plus 866 A • Remote Control
Remote Control, cont’d
4-10
MPX Plus 866 A • Remote Control
4-11
