L. BASS- Adjusts the amount of low frequency boost or cut
in the DRIVE channel. This control is post distortion and is
useful for adjusting the amount of “thump” or “chunk”
produced by the DRIVE channel.
M. DRIVE- When this button is pressed, the amp switches
from the NORMAL channel to the DRIVE channel. NOTE:
Pressing this switch disables the CHANNEL SELECT
footswitch button.
N. VOLUME- Adjusts the overall volume of the DRIVE
channel.
0. REVERB- Adjusts the amount of reverb present in both
the NORMAL and DRIVE channels.
P. FOOTSWITCH- Plug-in connection for a remote
footswitch to switch between NORMAL and DRIVE
channels and to turn the REVERB on and OFF. NOTE: Any
good quality patch cord will work with the remote
footswitch; however, a speaker grade cord is preferable to a
coax guitar cord when it’s available.
0. PREAMP OUT- This jack provides an unbalanced output
signal from the preamp. This jack can be used with the
POWER AMP IN jack (item R) as a patch point for effects.
R. POWER AMP IN- This jack provides an input directly to
the power amp. It automatically disconnects the preamp
signal when used. This is useful when using effects, or when
the the DELUXE 112 PLUS is used as a slave amplifier.
S. HEADPHONE- This jack provides as output to standard
stereo or mono headphones for private listening. NOTE: Use
of this jack automatically disables the main speaker.
CAUTION: Prolonged listening at high levels may be
hazardous to your hearing!
T. POWER SWITCH- Turns the AC power on and off. When
the switch is in off position, the amplifier is completely shut
down.
