To Fit the Wheel
— Fit the spare wheel seeing that the
location dowel fits into the location
hole in wheel disk.
— Refit trim and refit and tighten
uniformly the wheel fixing bolts in
criss-cross sequence.
— Remove the jack hand lever and
actuate handwheel F of extension
E and lower the car.
— Fully tighten the wheel bolts in
criss-cross sequence.
— Check that the newly fitted tire is
inflated to the correct pressure.
When repositioning the jack in the
trunk make sure extension E is properly
housed and Jack, bag and hand lever D
are correctly fastened by strap B.
JACKING UP AND
TOWING
When either the front or rear end
of car must be raised with a garage
jack, it is necessary to fit jack head
under front suspension cross rail, in-
terposing a suitably thick (abt. 3 cm
- I'A in.) wooden block, or rear
axle bulge.
If car needs towing with a rope
this must be attached to the spe-
cially provided front brackets.
34975
22
