3
Warnings and Safety information
CAUTION!
In order to avoid hazard these products
must be installed according to these
instructions.
Please follow installation information
carefully. If in doubt consult your local
building authority by-laws.
Failure to install the product correctly
could invalidate any warranty or liability
claims.
The product is to be connected to the
electrical supply only by a suitably
registered electrical person.
IMPORTANT!
Please make this information available to
the person responsible for installing the
product as it could reduce your installation
costs.
The cavity must be a completely sealed
box with no gaps. This will ensure the
cooling air flows under the product and
through the oven frame to give the correct
venting and cooling for the oven and
cabinet surround. Failure to seal the cavity
box may cause distortion of surrounding
cabinetry.
Read these instructions carefully before
installing or using this product.
Before you start
Ensure a suitable disconnection switch
is incorporated in the permanent wiring,
mounted and positioned to comply with the
local wiring rules and regulations. The switch
must be of an approved type installed in
the fixed wiring and provide a 3 mm air gap
contact separation in all poles in accordance
with the local wiring rules.
In Australia and New Zealand, a switch of the
approved type with a 3 mm air gap must be
installed in the active (phase) conductor of
the fixed wiring.
Ensure that the location of the oven
connection socket (if fitted) is outside the
installation space if the product is flush to the
rear wall.
Ensure the electrician provides sufficient
free length of mains cable to reach from the
bottom rear of the cavity to at least 1.5 metres
in front of the bottom edge of the opening.
The cable may enter the cavity from the side,
top or bottom, but entry must be at the rear
of the cavity.
Ensure that the benchtop and oven cavity are
square and level.
Use easy-to-clean finishes for the wall surfaces
surrounding the oven and cooktop. This
will help to remove any staining caused by
cooking fumes.
Check that the height of the product from the
floor suits the user.
Ensure that the oven door(s) will be clear of
obstructions when fully opened.
WARNING!
Cut Hazard
Take care - panel
edges are sharp.
Failure to use caution
could result in minor
injury or cuts.
