A SERVICE OF

logo

Open as PDF
next previous
9
Inline Mode
They say two ports are better than one…
Note
NetTool can’t tell you about what it doesn’t
see. NetTool must sense traffic on a network
or device so it can supply protocol or health
information.
Inline means NetTool is connected between two
devices simultaneously like a PC and hub. Use this
mode to verify that a PC will communicate properly with
the network.
afq02f.eps
⇒ Plug NetTool inline between the PC and the
network.
⇒ Power up the PC.
⇒ Select AutoTest. The example shown above is
NetTool connected inline between a PC and a
hub. The icons represent the discovered devices.
Check
AutoTest
(page 19) for more on the icons.