Garmin 4000 Manual

next previous

3GPSMAP 4000/5000 Series Installation Instructions

To ush mount a GPSMAP 4008/4208/4012/4212 chartplotter or a GPSMAP 5008/5208/5012/5212 chartplotter:

1. Theush-mounttemplateisincludedintheproductbox.Trimthetemplateandensureitwilltinthelocationatwhichyouwanttoush

mount the chartplotter.

Make sure the surface on which you mount the chartplotter has at least 7 in. (18 cm) of open space behind it to t the chartplotter and the

connected wires.

Make sure to leave approximately

in. (13 mm) of space on the right side of the chartplotter to access the SD card door.

Mount a 4008/4208/5008/5208 chartplotter 31

in. (80 cm), and a 4012/4212/5012/5212 chartplotter 39

in. (1 m) from a magnetic compass

to avoid interference.

2. Theush-mounttemplatehasadhesiveontheback.Removetheprotectivelinerandapplythetemplatetothelocationatwhichyouwantto

mount the chartplotter.

3. Using a

in. (10 mm) drill bit, drill one or more of the four pilot holes inside the corner of the template to begin cutting the mounting surface.

4. Usingthejigsaw,cutthemountingsurfacealongtheinsideofthesolidlineindicatedontheush-mounttemplate.Usealeandsandpaper

torenethesizeofthehole.Be very careful when cutting this hole. There is only a small amount of clearance between the case and

the mounting holes.

5. Install the four mounting studs into the chartplotter by screwing the shorter, threaded section into the back of the chartplotter. Use the

in.

(2 mm) Allen wrench to tighten the mounting studs until they stop. Do not overtighten - you may damage the mounting stud or the

mounting holes. The studs are coated with a reusable thread-locking patch applied at the factory.

6. Placethechartplotterintheholeandmakesurethatthemountingstudslineupwiththepilotholesontheush-mounttemplateaftercutting,

sanding,andlingthehole.Iftheydonot,markthelocationswherethestudswillfeedthroughthemountingsurface.

7. Using the center punch, indent the center of each of the 4 mm mounting-hole locations.

8. Using a 4 mm drill bit, drill the four mounting holes.

9. Install the rubber gasket on the back of the chartplotter. The top and bottom sections will line up with the holes. The side sections will line up

with the notches in the case (for the cover)

10. Place the chartplotter into the cutout. The four mounting studs should feed through the four mounting holes drilled in step 8.

11.Placetheatwashersandthelockwashersoverthemountingstuds.Thenthreadthehexnutsontothemountingstuds.Tightenallfourhex

nuts evenly until the chartplotter is snug against the mounting surface.

Chartplotter

Mounting studs ×4

Rubber gasket

Flat washers ×4

Lock washers ×4

Hex nuts ×4

Mounting surface

Flush Mounting a GPSMAP 4008/4208/4012/4212/5008/5208/5012/5212 Chartplotter