2 GPSMAP 5000 Series Owner’s Manual
Getting Started
GettinG
Started
Turning the Chartplotter On
NOTE: The rst time you power on your chartplotter, you must go through a setup sequence. See
“Initializing Chartplotter Settings”.
1. Press and release the Power key. After a few moments, the Warning screen appears.
Warning Screen Home Screen
2. Touch I Agree to open the Home screen.
Turning the Chartplotter Off
To turn the chartplotter off, press and hold the Power key.
Initializing Chartplotter Settings
The rst time you turn your chartplotter on, you must congure a series of initial settings. These
settings must also be congured when restoring factory settings (page 4). All of these settings can be
congured later from the Congure screen (page 36).
The initial settings are as follows:
Language—touch the language that you want shown on your screen.
Welcome—touch OK.
Position Format—specify the coordinate system to use for location readings.
Time Format
—select 12-hour, 24-hour, or UTC (Universal Time Code) to specify the format
in which time is displayed.
Time Zone
—select your time zone.
Units—select Statute, Metric, or Nautical to specify units for on-screen measurements.
Minimum Safe Depth—specify the minimum safe depth for your boat. Refer to your boat
specications for more information.
Minimum Overhead Clearance
—specify the minimum overhead clearance for your boat. Refer
to your boat specications for more information.
•
•
•
•
•
•
•
•
