StreetPilot 7200/7500 Owner’s Manual 49
APPENDIX
To slide the mounting cradle into the base on
the mounting plate:
Sliding the Mount in the Base
Locking lever
1. Slide the bottom of the mounting cradle into the
mounting base.
2. Slide the base’s locking lever to the right (locked).
3. Plug the power adapter into a 12-Volt receptacle
in your vehicle.
4. Route the cable so it does not interfere with
vehicle operation.
DR Cable Wiring
The Dead Reckoning (DR) Cable is used by the 7500
to provide dead reckoning, which allows the 7500 to
continue to get navigation guidance even if it loses GPS
reception.
The Dead Reckoning (DR) cable connections must be
installed by a Garmin-authorized, licensed installer.
WARNING: The terms of the Garmin Warranty
require that the DR (Dead Reckoning) Cable
with bare wire leads be installed by Garmin-
authorized, licensed installers.
The DR cable is also needed for both the 7200 and 7500
to use a Backup Camera. The DR cable must be installed
to the Reverse Light Switch. For information about
configuring the Backup Camera, see page 32.
