4 Quest
®
2 Owner’s Manual
GettInG started > VehIcle InstallatIon
Vehicle Installation
You can install and store the Quest 2 in the vehicle mount. The
Quest 2 runs off power from your vehicle when the ignition is
turned on. Be sure the vehicle ignition is turned off before you
install or remove the unit from the mount.
To install the Quest 2 in the mount:
1. Flip up the GPS antenna to a 90° angle on the back of the
Quest 2.
2. Insert the bottom of the Quest 2 into the bottom of the
mount, as shown. The antenna ts through the opening in
the back of the mount.
3. Snap the Quest 2 back into the mount so that it is fully
seated.
Tab
To remove the Quest 2, push the tab
up and pull the Quest 2 forward.
NOTE: Make sure the tabs are located and locked correctly.
To remove and store the Quest 2:
1. Push the tab up that holds the Quest 2 in place (see above).
2. Pull the Quest 2 forward and then out of the mount.
