A SERVICE OF

logo

7
Using the USB Hub:
There is a built-in USB hub on your Keypad that gives you two additional USB ports. To use the USB hub on your Keypad, please follow the
instructions below:
1. Make sure your computer is turned on and you have properly installed your Keypad following the Installation section in this manual.
2. Connect a USB device into one of the USB ports on the top of your Keypad.
3. Your computer will detect the USB device connected to your Keypad.
4. Depending on the USB device you are connecting to your Keypad, please refer to your USB device user’s manual to complete the
installation.
NOTE: The built in 2 port USB Hub can support a combined power consumption of approximately 300mA to the device(s) connected to the
Keypad. It is recommended to connect only low power consumption devices such as a flash drive, mouse, keyboard, or any other low power
USB devices to the USB Hub. USB powered enclosures or USB hard drives might experience read/write errors if connected to the USB Hub.