Installation
313212A 3
Installation
Location
Install the gun flush box module enclosure (1) within 15
ft (4.5 m) of the RoboMix, to ensure that the cable (23)
will reach the RoboMix. The module is approved for use
in a hazardous location. See F
IG. 1.
Mount the Enclosure
1. See Dimensions, page 13.
2. Ensure that the wall and mounting hardware are
strong enough to support the weight of the equip-
ment, fluid, hoses, and stress caused during opera-
tion.
3. Using the equipment as a template, mark the
mounting holes on the wall at a convenient height
for the operator and so equipment is easily accessi-
ble for maintenance.
4. Drill mounting holes in the wall. Install anchors as
needed.
5. Bolt equipment securely.
• To avoid electric shock, ground all equipment.
Turn off equipment power and shut off power at
main circuit breaker before installing.
• All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations.
• Do not substitute system components as this
may impair intrinsic safety.
To reduce the risk of serious injury, including fluid
injection, splashing, pinching or injury from moving
parts, relieve pressure before installing the kit. Fol-
low the Pressure Relief Procedure in the ProMix
2KS Operation or Service manual.
