Installation
6 311688D
Mounting the Pump
• For ease of operation and service, mount the pump
so the air inlet, fluid inlet, and fluid outlet ports are
easily accessible.
• Mount the pump in a well-ventilated area with suffi-
cient clearance on all sides for operator access and
servicing.
• The pump must be mounted horizontally as shown
in F
IG. 1. Be sure that the pump is level in all direc-
tions and that the cylinder housing (54) is positioned
on the bottom. See F
IG. 1.
• The pump can be floor mounted or mounted on a
wall using mounting kit 246495.
• Be sure the mounting can support the weight of the
pump, hoses, and accessories as well as the stress
caused during operation. The pump has two mount-
ing holes for 0.31 in. (8 mm) screws. See the
Dimension drawing on page 26.
Wall mount using kit 246495:
1. Use the bracket (15C022) as a template to drill 2
0.38 (9.6 mm) diameter holes in the wall.
2. Loosely attach bracket (15C022) to the wall with
anchors and screws (8 mm) long enough to prevent
the bracket from vibrating during operation.
3. Remove bracket from the wall and fasten it to the
pump using the 4 screws (116899) and 1 lock
washer (100028) included in the kit.
4. The lock washer must be used in the unpainted hole
to ensure proper grounding of the bracket.
5. Mount the bracket with the pump attached to the
wall and tighten.
F
IG. 1. Mounting the Pump
Floor Mount
Hexagonal screw (2 required)
Hexagonal
screw
(2 required)
Compressed air
connection
Fluid
Inlet
Cylinder
Housing (54)
Fluid
Outlet
Wall Mount
Wall
Mount
Bracket
TI2133A 2
TI2469A
