Operation Characteristics
12 313384B
Operation Characteristics
• Always have material outlet plug installed in opening
(K or L) not in use when material is in hopper. If plug
is removed, hopper will drain out.
• Always have material hose installed in opening (K or
L) when material is in hopper. If hose is removed,
hopper will drain out through pump.
• Air pressure is controlled with pressure control knob
(J) and displayed on gauge.
• Gun air pressure is regulated using air pressure
control on sprayer (U) as well as gun air valve
located on gun handle (23). Site gauge on sprayer
allows duplication of air pressure setting. Gun air
valve (23) allows for additional air pressure adjust-
ment.
Always start system with compressor air relieved. See
Pressure Relief Procedure, page 6.
ti3787b
K
L
H
J
closed
ti4005a
23
